The bar is clamped in a metal vise, so the vise is very slightly heated and that side of the bar is much cooler.
Taken using the Topdon Android attachment.
The bar is clamped in a metal vise, so the vise is very slightly heated and that side of the bar is much cooler.
Taken using the Topdon Android attachment.
The fact that this comment exists, and that it’s the top votes, is why I’m on Lemmy.
Nice tip! When I buy a thermal cam, I’ll put in an order kapton tape too.
I do have some kapton tape. I’ve heard black sharpie on masking tape too. The cutoff piece was definitely uncomfortable to hold but not in the range of instant burns; also a pretty dull surface. I wouldn’t be surprised if it were a bit about 107⁰F but I don’t think it was near 300⁰F.
Haven’t used sharpie and masking tape before, but I’ve used kapton at relatively high temps (500F). Contact pain for metal typically starts around 113F (45C), but I was referring to right where you were cutting, not where you were holding.